Technical Specifications - Scheppach 19013 03901 Originalbetriebsanleitung

Included with the saw bench
Bench circular saw Precisa 4.0
Carbide tipped saw blade ø 270 mm
Longitudinal fence
Cross cut gauge
Suction connection
Assembly accessories
Push stick
Operating instructions
Table lengh extension

Technical specifications

Length
Width
Height
Saw blade
Saw blade
Cutting height at
90°/45°
Cont. cutting height
adjust.
Continuos swing range
Bench size-length/width
Bench height
Speed
Weight
Suction connection
piece ø
Suction connection
piece ø
ambient conditions
Motor One phase
Nominal input
P1 kW 2,7
Output power
P2 kW 2,0
Noise parameters
The noise emmision values at the work place, determined
according to EN 23746 (acoustic power levels) and
EN 31202 (acoustic pressure levels) with a correction
factor k3 calculated according to appendiy A.2 of
EN 31204, based on operating conditions listed in
ISO 7904, appendix A, are:
Acoustic power level in dB
Idling L = 91,2 dB(A)
Operating L = 97,7 dB(A)
Acoustic pressure level in dB
Idling L = 80,6 dB(A)
Operating L = 87,6 dB(A)
A measuring uncertainty coefficient (K=4 dB9 applies to the emission values liste
above.
14 english
mm 990
mm 680
mm 1010
max. mm 270
min. mm 200
max. mm 85/56
mm 0-85
0°-45°
mm 800/680
mm 850
rpm 4000
kg 130
mm 100
mm 100
C° -5 / +35
three phase
3,6
2,9
Dust emmision parameters
The dust emmision parameters, measured according to
the principles for measuring dust emmisions (concentrati-
on parameter) for woodworking machines specified by the
German wood professional commite, are now 2 mg/m³.
Dust emissions can therefore be continuosly kept within
the range allowed under currently valid German regula-
tions by connecting the machine to a vacuum exhaust
system with an airflow speed of at least 20 m/S.
Assembly
Assembly tools
1 cross head screwdriver
1 open-end spanner
1 hammer 500 g
not included
1 spanner
1 hexagon allen key
1 hexagon allen key
1 fixing pin
included
For packaging reasons your scheppach ts Precisa 4.0 bench
circular saw is delivered in semi-assembled state.
Assembling the frame
Fig."A"
Place the scheppach Precisa 4.0 bench
circular saw with the bench top on a flat, clean surface.
Place a sheet or similar on the surface
to protect the bench top.
Assemble as folIows:
Switch/plug combination, switch console,
feet, trimming panels
Fig."A1"
Flat round screws
for securing the switch are in aseparate plastic pack.
First screw the switch to the switch
platewith
4 flat round screws
Ejection - suction connection
Fig."A2"
Fit the suction connection (2) only in conjunction with
the scheppach suction system woova 3.0.
4 flat round self-tapping screws
For the remaining assembly work stand the scheppach
Precisa 4.0 bench circular saw on its feet.
PH 2
size 13
size 19/30
size5
size6
B4.2 x 16
B4.2x16
B4.2x13