Bender ISOMETER isoGEN423 Kurzanleitung Seite 26

Connection
Connection type................................................................................................................................Push-wire terminal
Nominal current....................................................................................................................................................≤ 10 A
Conductor sizes .............................................................................................................................................AWG 24-14
Stripping length ....................................................................................................................................................10 mm
Rigid......................................................................................................................................................... 0.2...2.5 mm²
Flexible without ferrule......................................................................................................................... 0.75...2.5 mm²
flexible with ferrules, with/without plastic collar................................................................................ 0.25...2.5 mm²
Multiple conductor, flexible withTWIN ferrule with plastic sleeve ....................................................... 0.5...1.5 mm²
Opening force........................................................................................................................................................... 50 N
Test opening, diameter....................................................................................................................................... 2.1 mm
Other
Operating mode ........................................................................................................................... Continuous operation
Mounting..................................................................................................... Cooling slots must be ventilated vertically
Degree of protection, built-in components (DIN EN 60529) ................................................................................. IP30
Degree of protection, terminals (DIN EN 60529) ................................................................................................... IP20
Enclosure material .................................................................................................................................... Polycarbonate
DIN rail mounting acc. to................................................................................................................................. IEC 60715
Screw fixing ......................................................................................................................... 2 x M4 with mounting clip
Weight................................................................................................................................................................ ≤ 150 g
Standards, approvals and certifications
The ISOMETER® has been developed in compliance with the following
standards:
DIN EN 61557-8 (VDE 0413-8): 2015-12/Ber1: 2016-12
 
IEC 61557-8 -8:2014/COR1: 2016
 
26 isoGEN423_D00221_01_Q_DEEN/03.2018