Installation And Connection; Din Rail Mounting; Screw Mounting - Bender ISOMETER isoGEN423 Kurzanleitung

4. Installation and connection.

DANGER

DIN rail mounting

Snap the mounting clip at the rear of the device onto the DIN rail so that it sits
securely.

Screw mounting

Use a tool to position the rear mounting clips (a second mounting clip is requi-
red, see ordering information in the manual) so that it protrudes over the en-
closure. Fix the device with two M4 screws (as shown below)
36
Fig. 6.1: Dimension diagram of isoGEN423 (all dimensions in mm)
isoGEN423_D00221_01_Q_DEEN/03.2018
Risk of electric shock!
Avoid any physical contact with active conductors and
ensure compliance with the regulations for working on
electrical installations.
Accessory
2
2
Click
M4
1
2
3
17