L) Mounting The Landing Gear; M) Canopy; Installing The Wing; Applying The Decals - Reely Soarstar Bedienungsanleitung

l) Mounting the landing gear

The kit includes two eye rods 210 x 1 mm for the wing support. Put a rubber
sleeve into each eye. Also see illustration 16.
Attach a rubber sleeve with eye rod (2), a plastic spacer (3), and the wheel (4)
on the wheel axle (1) and fasten the unit using an adjusting ring and a screw
(5). Install the adjusting ring so that the wheel can be turned easily without too
much play.
Install the tail skid (7) on the tail boom below the elevator unit (6). To do that,
pre-drill with a 1mm drill and glue in the tail skid.

m) Canopy

The canopy (1) is fixed with Velcro fastener. Attach a small strip of Velcro fastener
(2) into the recesses in the sides. Attach the counterpart (3) on the inside of the
fuselage.
It is a proven method to provide the battery and the speed controller with "forced
cooling". The rear part of the fuselage is already equipped with suitable openings.
At your own discretion, drill holes into the canopy depending on the used battery
type. The holes should have a diameter of at least 10 mm.
n) Installing the wing
Attach the wing with the wing guide (1) over the plug on the fuselage (2). The
wing guide (1) must be touching the silicon tube (3).
Fix the wing on the fuselage from the top using two rubber rings (4). Connect
the motor to the speed controller (5).
Hook the eye rods with the rubber sleeves into the hooks on the wing (6).
o) Applying the decals
You will find several stickers on the decal sheet. See the package for an overview of where to attach the stickers. Of course, you can as well attach the stickers
as you please.
Illustration 14
Illustration 15
Illustration 16
29