Inserting/Changing The Batteries; A) Outdoor Sensor; B) Weather Station; Connection (Power Adapter) - Eurochron Monalisa 1538488 Bedienungsanleitung

10. Inserting/changing the batteries

a) Outdoor sensor

• The battery compartment is located on the bottom of the rainfall gauge.
• Loosen the screw with a Phillips screwdriver and remove the battery compartment
cover.
• Insert 3 AA batteries, observing correct polarity. Observe the polarity as indicated next
to the battery compartment.
• Close the battery compartment.
Make sure that the rubber sealing ring around the battery compartment is
installed correctly, so that no water can enter the product.
The red LED indicator on the bottom flashes in an interval of 12 seconds.
Replace the batteries as soon as the battery symbol appears in the lower right area (OUTDOOR) of the
display.

b) Weather station

• Remove the battery compartment cover.
• Insert one CR2032 button cell with correct polarity. The positive
(+) terminal must point outwards.
• Close the battery compartment.
• As soon as the coin cell is inserted, all display segments will
appear briefly. Within 8 seconds, the weather station will begin
searching for the time signal.
If no display appears after the button cell is inserted, press the RESET button on the weather station.
It is possible that the time signal cannot be received immediately due to atmospheric interference.
The button cell only serves as an emergency power supply. If you replace the button cell, the AC adapter
must be connected, otherwise all settings will be lost.
Replace the button cell as soon as the battery symbol appears to the left of the time.

11. Connection (power adapter)

• Connect the DC plug with the power supply connector on the weather station.
• Connect the power adapter to a common household mains socket.
39