Inserting A Module; Removing A Module - Auerswald COMpact 4000 Anleitung

Installation and Commissioning
 Discharge electrostatic charges from yourself before touching the circuit
Important: Before you insert a COMpact 2BRI module, first make the nec-
essary settings on the module (operating modes and terminators).

Inserting a Module

1.
Slide the module into the
board guides with the
component side pointing
to the left.
2.
Press the module up-
ward until the board lock
clicks into place.

Removing a Module

1.
Unlatch the board
lock, for example with
your right thumb.
2.
Remove the module
with your other hand.
36
boards with your hands or any tools. To do this, touch a (preferably
earthed) metal object, such as the PBX's earthing terminal or a com-
puter case.
COMpact 4000 - Firmware V6.4 - Setup V02 07/2015