Auerswald COMpact 4000 Anleitung Seite 24

Important Information
 Pull out the power plug of the PBX before commissioning a qualified
 Remove any voltage from the device by discharging any capacitors
 If available, also disconnect the devices from auxiliary power sources
 Do not make any structural changes to the device.
 For some installation and maintenance work, it is necessary to open the
 Be sure to follow the relevant regulations when handling 230 V system
 Only operate the device when the casing is closed.
 Only operate the device mounted on the wall.
Warning: Liquid that penetrates the casing can cause life-threatening elec-
tric shocks and damage to, or destruction of, the PBX.
 Only operate the PBX in closed, dry rooms.
 Only clean the device with a soft moist cloth or anti-static cloth.
Warning: Damaged connection lines or damage to the casing or the PBX
can cause life-threatening electrical shocks.
 Only connect the device's connection cable with sockets that are
 Make sure that the Schuko socket for connecting the PBX is properly
 Have damaged connection lines replaced immediately.
 Only use original accessories and original replacement parts.
 Contract a professional to complete any necessary repairs without
Warning: Power surges, which can occur during electrical storms, can
cause life-threatening electric shocks and can damage or destroy the PBX.
 For this reason, do not mount the PBX during an electrical storm. Avoid
 Hire a qualified electrician to lay the cables within the building – includ-
 Protect the devices by installing overvoltage protection.
24
electrician to open the casing to install an expansion module or perform
switching or connecting services.
present, if necessary. In the case of a malfunction, the electrolytic
capacitor for the switch-mode power supply can remain charged for a
long time even after being turned off.
(for example, UPS).
PBX while it is in operation (qualified electrician only). Make sure that
the PBX is never left unattended while working with an open casing.
voltage and devices attached to the mains.
designed for that purpose.
connected (according to VDE 0100). The power socket must be located
near the PBX and be freely accessible at all times.
delay. Please contact your qualified electrician or the manufacturer
directly.
disconnecting and connecting lines during an electrical storm.
ing the cable to the door terminal.
COMpact 4000 - Firmware V6.4 - Setup V02 07/2015