15.3.5 Bevel cut
Release the vertical angle lock (16). Set the desired angle.
Tighten the the vertical angle lock.
15.4 Operation modes
15.4.1 Miter cuts
Ideal for cutting short workpieces in miter and/or bevel angles.
For miter cuts fix the saw unit on the sliding bars with drag lock.
Place the material to the fence and fix the material additionaly with the downholder.
Prepare to cut and perform the cutting operation.
Swing the saw unit back up, release the accelerator lever and wait until the electric saw brake
stops the saw.
Now you can take the workpiece away
15.4.2 Sliding cuts
Sliding cuts are ideal for performing longer cuts
Fix the material!
Pull the saw towards your body (drag lock open).
Switch the machine on, wait until saw blade reaches full speed.
Now swing the saw arm down and let it work its way slowly through the material. Now push
the saw arm slowly backwards.
Advantage: If the material cracks or material parts are catapulted, then not towards the operator.
Disadvantage: You MUST fix workpiece additionaly with downholder to prevent it from kickback.
15.4.3 Slot cuts
Adjust the cutting depth for slut cuts as desired.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
OPERATION
33
KAP 305ECO