Shutting Down; Maintenance And Care; Faults - Kärcher SE 4002 Originalbetriebsanleitung

Vacuuming hard surfaces
Illustration
 Insert the hard surface inlay into the
floor nozzle. The bristles should point
towards the front.
Vacuuming carpeted floors
Illustration
 Work without the hard surface insert.
 Use the surrounding air separator to
adapt the suction force.
Note:
Close the surrounding air separator
again after use!
Wet vacuum cleaning
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full, a float closes
the suction opening, and the appliance
works at a higher speed. Switch off the ap-
pliance immediately, and empty the con-
tainer.
 Use washing nozzle to vacuum up wet
dirt/water.
If you use a crevice nozzle:
 Attach and secure the adapter for wet/
dry vacuuming. Install the crevice noz-
zle directly to the adapter.
 Switch on suction (position I).
Illustration
 Open the surrounding air separator if
water is suctioned from a tank. Close it
again after use.
 Empty the full reservoir (refer to chapter
"Empty reservoir").

Shutting down

 Turn off the appliance.
 Empty the full reservoir (refer to chapter
"Empty reservoir").
 Rinse the reservoir thoroughly with
clear water.
 Separate the handle, the spray/suction
hoses and the wash nozzle from each
other; open locking lever to achieve this
(centre position),
 Flush the accessories separately under
running water and let air dry.
 Clean the foam filter under running wa-
ter; let it dry before reinserting it.
 Leave the appliance open to let it dry.
 Storing the appliance. Store the ac-
cessories on the appliance and store in
dry rooms.

Maintenance and Care

DANGER
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorised customer service.
WARNING
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
Clean the spray nozzle
With an uneven spray jet.
Illustration
 Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
Clean the sieve in the fresh water
1 x year or as needed.
Illustration
 Turn the lock and loosen it. Take out
the sieve and rinse it with water.
No water exiting from nozzle
 Fill up fresh water reservoir.
 Check the fresh water reservoir for cor-
rect fit.
 Detergent pump defective, contact cus-
tomer service.
Spray stream uneven
 Clean the spray nozzle of the washing
nozzle.
– 10
EN
reservoir

Faults

17