Maintenance Schedule; Troubleshooting; Discard; To Clean The Product - Meec Tools 018633 Bedienungsanleitung

7.1

Maintenance schedule

EN
WARNING! Stop the product and disconnect it
from the power supply before you clean or do mainte-
SV
nance to it.
NO
WARNING! Collected metal dust on the product
can cause a short circuit between the internal compo-
nents and the housing, which can result in electric shock.
DA
WARNING! The product cannot be repaired by the
PL
user. For servicing and reparation refer to an approved
service center.
DE
CAUTION! Do not stop the product while it is under
load, this can decrease the working life of the switch.
FI
FR
8

Troubleshooting

Problem
NL
The product does not start.
The product does not cut or grind
effectively.
9

Discard

● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
16
● Keep the protective cover, ventilation openings, and
motor clean. Remove dust and dirt with a cloth, brush
or blow them out with low-pressure compressed air.

7.2 To clean the product

or other liquids. Make sure that no water gets into the
product when you clean it.
the product, do not use harsh detergents or abrasive
cleaners.
● Clean the product with a dry cloth if necessary.
● Use compressed air or a brush to clean hard to get to
areas.

Possible cause

The product is not connected to a
power outlet.
The power cable is damaged.
The power outlet is not serviceable.
The carbon brushes are worn.
The power switch is damaged.
The disc is not applicable for the type
of material.
The disc is worn.
WARNING! Do not soak the product in water
CAUTION! To prevent damage to the surface of
Connect the product to a power
outlet
Refer to an approved service center
to replace the power cable.
Connect the product to a serviceable
power outlet.
Refer to an approved service center.
Refer to an approved service center.
Use an applicable disc.
Replace the disc.
Task