To Sharpen A Workpiece; Maintenance; To Clean The Product; To Replace A Wheel - Meec Tools 026749 Bedienungsanleitung

5
Connect the product to a power outlet and start the
product.
6
Use a wooden spreader to apply the honing paste
equally over the surface of the honing wheel.

4.8 To sharpen a workpiece

Caution! Do not use the wet grinding stone without
the water container in position and filled with water.
Note! Replace the water in the water container regularly
during operation.
(Figure 8-9)
Use the tool support or a grinding jig (sold separately) to
achieve a good grinding result for the specific type of
workpiece.
1
Start the product and let it reach full speed.
2
Put the workpiece on the tool support.
3
Move the workpiece slowly forward until it reaches
the wheel and apply a light pressure.
4
Move the workpiece from side to side over the
surface of the wheel to get an even result.
5

Maintenance

Warning! Always disconnect the product from the
power outlet before you do any maintenance on the product.
5.1

To clean the product

Clean the product regularly.
1
Remove the water container and rinse it with water.
2
Clean the product with a dry cloth.

5.2 To replace a wheel

1
Loosen and remove the locking nut.
2
Remove the outer washer and the wheel.
3
Attach a new wheel.
4
Attach the outer washer and tighten the locking nut.
6

Storage

Caution! Do not store the product with water in the
water reservoir. This can cause deterioration of the grinding
wheel.
● Store the product in a dry and frost-free place protected
from direct sunlight.
7

Disposal

● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
8

Technical data

Specification
Voltage
Power
Speed
Disc diameter
Hole diameter
Disc thickness
Cord length
Protection rating
Length
Width
Height
Weight
Sound pressure level, LpA
Measured sound power level, LwA
Warning! Always wear hearing protection!
Warning! The actual vibration and noise level when
using tools may differ from the specified maximum value,
depending on how the tool is used and the material. It is
therefore necessary to determine which safety precautions
are required to protect the user, based on an estimate of
exposure in actual operating conditions (taking into account
all stages of the work cycle, e.g. the time when the tool is
switched off and when it is idling, in addition to the start-up
time).
Value
230 V
120 W
115 /min
200 mm
12 mm
40 mm
1.8 m
IP20
370 mm
320 mm
274/379 mm
8.7 kg
68.7 dB(A), K=3 dB
81.7 dB(A), K=3 dB
35