To Install The Auxiliary Handle; Operation; To Do Before You Operate The Product; To Start And Stop The Product - Meec Tools 018633 Bedienungsanleitung

5
Tighten the outer flange with the spanner.
EN

4.3 To install the auxiliary handle

SV
Figure 4
1
Install the auxiliary handle on the applicable side
NO
of the gear housing.
2
Turn the handle until the handle is fully tightened.
DA
5

Operation

PL
5.1 To do before you operate the
product
DE
WARNING! Risk of personal injury. The rotating
accessory and the workpiece become very hot during
operation. Do not touch the rotating accessory or the
FI
workpiece until they have become cool.
● Make sure that handle and the disc guard are correctly
FR
installed.
● Make sure that the product is not damage.
NL
● Safety the workpiece before operation.
● Do not apply too much pressure to the product during
operation.

5.2 To start and stop the product

CAUTION! During operation, keep one hand on the
main handle and the other hand on the auxiliary handle.
NOTE! If there is a power supply failure, the undervoltage
relay trips. This relay prevents an unexpected start when
the power supply is restored. To start the product again,
stop and start the product.
Figure 5
1
Push the safety lock forward (A) and push the
power switch (B) to start the product.
2
Release the power switch to stop the product.

5.3 Different grinding accessories

WARNING! Do not use a grinding accessory that
has a maximum permitted speed lower than the speed of
the product.
● Always check the maximum permitted speed or
peripheral speed of the grinding accessory before use.
14
● Always use the supplied flanges with the grinding
accessories.
● Make sure that the contact surface of the flange is at
least the same size as the contact surface of the
accessory.
● When you use grinding accessories with threaded
shaft, make sure that the end of the spindle does not
touch the perforated plate of the grinding accessory.
Contact between the spindle end and the perforated
plate can cause damage to the grinding accessory.
● Make sure the accessory is correctly attached on the
spindle flange.