Parkside Performance PSSAP 20-Li E5 Bedienungsanleitung Und Originalbetriebsanleitung Seite 20

˜ Speed control
Control the speed progressively with
o
the on/off s itch
Pressure
Gentle
Strong
˜ LED work light
NOTE
This product is equipped with a
u
L D or light
immediate working area to improve
visibility in poorly illuminated areas.
The LED work light
o
automatically as long as the product is
switched on.
˜ Trial run
NOTE
Always carry out a no-load trial run
u
before starting work and after every
replacement of the sa blade
S itch the product off immediately
u
if the sa blade
smoothly, if considerable vibration
occurs or if you hear abnormal
noises.
˜ Working instructions
CAUTION! Risk of injury and
m
damage to property!
Wear protective gloves when
u
handling the sa blade
way, you avoid injury from cuts.
Do not use any blunt or bent saw
u
blades / or saw blades which
[ ] [ ]
are damaged in any other way.
Before sawing the workpiece, check
u
for hidden foreign objects such as
nails and screws and remove them.
18 GB/IE/NI/MT
:
6 ] [
Speed
Lower speed
Higher speed
to illuminate the
[ ]
lights up
[ ]
/
[ ] [
/ is not running
[ ] [ ]
/ . In this
[ ] [ ]
CAUTION! Risk of injury and
m
damage to property!
Always insert a suitable saw blade
u
/ .
[ ] [ ]
Secure the workpiece with the aid of
u
clamping devices on the workbench.
Apply only as much pressure as
u
is required for sawing. If there
is excessive pressure, the saw
blade /
[ ] [
S itch the product off immediately
u
if the sa blade
spread the saw cut and carefully pull
the saw blade out.
Always stand to the side of the
u
product when working.
Always make sure that the
u
workplace is well ventilated.
Avoid over-stressing the product
u
while working.
Saw the material at a constant
u
speed.
.
˜ Cutting works
]
1. erify the sa blade
touching the workpiece.
2. Switch the product on.
3. Apply the base plate
workpiece.
4. Use even pressure, advancing at a
steady pace when making the cut.
You can make horizontal, diagonal, or
vertical cuts.
5. hen you are finished
S itch the product off.
–
Pull the sa blade
–
workpiece.
may bend and break.
]
/ jams. Try to
[ ] [ ]
/ is not
[ ] [ ]
to the
[ 4 ]
/ out of the
[ ] [ ]