Parkside Performance PSSAP 20-Li E5 Bedienungsanleitung Und Originalbetriebsanleitung Seite 15

shoc and fire contact ith a gas pipe
can result in an explosion. Damage
to a water pipe can lead to property
damaged and electric shock.
k) Hold the power tool tightly with both
hands while working and ensure
a secure footing. The power tool is
guided more securely with both hands.
l) Secure the workpiece. A workpiece
that is retained with clamping products
or a vice is held more securely than
with your hand.
m) Wait until the power tool has
stopped before placing it down. The
accessory tool can tilt and lead to loss
of control over the power tool.
n) Do not saw any materials (e.g.
lead-based paints and coatings or
materials containing asbestos) whose
dust can be harmful.
WARNING!
m
Do not use any accessories that are
u
not recommended by PARKSIDE.
This can lead to electric shock and
fire.
˜ Vibration and noise reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low-vibration and low-noise
operating modes as well as wear personal
protective equipment.
Take the following points into account to
minimise the vibration and noise exposure
risks:
Only use the product as intended by
its design and these instructions.
Ensure that the product is in good
condition and well maintained.
Keep tight grip on the handles/grip
surface.
Maintain this product in accordance
with these instructions and keep it well
lubricated (where appropriate).
Plan your work schedule to spread any
high vibration tool use across a longer
period of time.
˜ Behaviour in emergency
situations
Familiarise yourself with the use of this
product by means of this instruction
manual. Memorise the safety warnings
and follow them to the letter. This will help
to prevent risks and hazards.
Always be alert when using this
product, so that you can recognise and
handle risks early. Fast intervention
can prevent serious injury and damage
to property.
S itch the product off and remove the
battery pack if there are malfunctions.
Have the product checked by a
ualified professional and repaired if
necessary, before you operate it again.
˜ Residual risks
Even if you are operating this product
in accordance with all the safety
requirements, potential risks of injury and
damage remain. The following dangers
can arise in connection with the structure
and design of this product:
Health defects resulting from vibration
emission if the product is being used
over long periods of time or not
adequately managed and properly
maintained.
NOTE
This product produces an
u
electromagnetic field during
operation This field may under some
circumstances interfere with active
or passive medical implants!
GB/IE/NI/MT 13