Parkside Performance PSSAP 20-Li E5 Bedienungsanleitung Und Originalbetriebsanleitung Seite 14

g) Follow all charging instructions
and do not charge the battery pack
or tool outside the temperature
range speci ed in the instr ctions.
Charging improperly or at
temperatures outside the specified
range may damage the battery and
increase the ris of the fire.
CAUTION! RISK OF
EXPLOSION! Never charge
non-rechargea le atteries
Protect the rechargeable
battery from heat, for example
max. 45 C
from continuous exposure
to s nlight
moisture. There is a risk of
explosion.
Service
a) Have your power tool serviced by
a ali ed repair person sing onl
identical replacement parts. This will
ensure that the safety of the power
tool is maintained.
b) Never service damaged battery
packs. Service of battery packs
should be only be performed by the
manufactured or authorized service
providers.
˜ Safety instructions for
reciprocating saws
a) Hold the power tool by insulated
gripping surfaces when performing
an operation where the accessory
tool may contact hidden wiring.
Accessory tools contacting a "live"
wire may make exposed metal parts
of the power tool "live" and could give
the operator an electric shock.
12 GB/IE/NI/MT
re ater and
b) Use clamps or another practical
way to secure and support the
workpiece to a stable platform.
Holding the workpiece by hand or
against your body leaves it unstable
and may lead to loss of control.
c) Keep hands away from the sawing
area. Do not reach underneath the
workpiece. Upon contact with the
blade there is a risk of injury.
d) Only when the power tool is turned
on should the sawing blade be
moved against the workpiece. There
is a risk of kickback if the accessory
tool jams in the workpiece.
e) Make sure that the base plate
is securely placed against the
workpiece during sawing. The saw
blade can tilt and lead to loss of
control over the power tool.
f) A ter o ha e nished
the po er tool o and do not p ll
the saw blade out of the cut until it
has come to a standstill. In this way
you will avoid any kickback and can
safely put down the power tool.
g) Use only undamaged saw blades
in perfect condition. Bent or blunt
blades can brea
cut or cause kickback.
h) Do not brake the saw blade after
s itching the prod ct o
applying side pressure. The saw
blade may be damaged, break or
cause a kickback.
i) Tighten the material rml . o not
support the workpiece by hand or
foot. Do not touch any objects or the
ground with the saw running. There
is a risk of kickback.
j) Use suitable detectors in order to
nd hidden s ppl lines or as the
local utility company. Contact with
electrical cables can lead to electric
or t rn
adversely affect the