Parkside Performance PSSAP 20-Li E5 Bedienungsanleitung Und Originalbetriebsanleitung Seite 18

2. Connect the mains plug of the
charger to a mains outlet.
[ ]
3. hen the battery pac
charged:
Disconnect the mains plug of the
–
charger from the mains outlet.
[ ]
emove the battery pac
–
the charger
[
˜ Attaching/removing the
battery pack
(Fig. D)
Attaching the battery pack
1. Push the battery pac
handle .
[ 7 ]
2. nsure the battery pac
noticeably in place.
Removing the battery pack
1. Press the release button
battery pac .
[ ]
2. Pull the battery pac
handle .
7 ] [
˜ Checking the battery pack's
charging level
(Fig. B)
Check battery pack's charging level:
o
Press the button
level L Ds show the charging level
[ ]
as follows:
Charging level LEDs
Green
Orange
Red
16 GB/IE/NI/MT
is fully
[ ]
from
[ ]
.
]
into the rear
[ ]
clicks
[ ]
on the
[ ]
from the rear
[ ]
. The charging
[ ]
Charging level
Maximum
Medium
Low
˜ Assembly
˜ Adjusting the base plate
(Fig. E)
WARNING!
m
Al ays s itch the product off
remove the battery pac
let the product cool down before
making any adjustments!
CAUTION! Risk of injury!
m
Sa blades
and become hot during use.
Always wear protective gloves
when handling saw blades.
CAUTION! Risk of injury!
m
emove the sa blade
u
from the product before adjusting
the base plate
[ 4 ]
removing the saw blade").
Do not use the product without
u
having inserted the base plate
NOTE
The base plate
u
and s ivelled to different positions
to adapt to the workpiece.
1. nloc the base plate
loc ing lever
[ 1 ]
direction.
2. Adjust the desired position of the base
plate : Push the base plate in or pull
4 ] [
the base plate out.
3. Loc the base plate
loc ing lever
1 ] [
direction.
4. Chec if the base plate
locked in place: Pull the base plate
away from the product.
If the base plate can not be pulled out,
the base plate is locked properly.
and
[ ]
/ can be sharp
[ ] [ ]
/
[ ] [ ]
(see "Inserting/
.
[ 4 ]
can be adjusted
[ 4 ]
: Turn the
[ 4 ]
in a counter-clockwise
: Turn the
[ 4 ]
in a clockwise
is securely
4 ] [