Troubleshooting - Parkside Pdos 200 C2 Originalbetriebsanleitung

GB MT
Waste electrical and electronic
equipment (WEEE) must not be dis-
posed of with domestic waste.
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at the
end of its useful life.
Directive 2012/19/EU on waste electrical
and electronic equipment:
Consumers are legally obliged to recycle
electrical and electronic equipment in an en-

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Device works with in-
terruptions
Engine is slowing down
and stops
Grinding disc does not
rotate smoothly, ab-
normal noises can be
heard
Grinding tools do not
move even though the
motor is running
28
Possible Cause
No mains power supply
On/Off switch (12) defective
Defective motor
Internal loose contact
On/Off switch (12) defective
Tool overloaded
Grinding disc nut (26) loose
Grinding disc (3/8) defective
Spark guard (1) or workpiece
support (9) set incorrectly
Grinding disc nut (26) loose
Workpiece residues or
residues from grinding tools
block drive
vironmentally sound manner at the end of its
life. In this way, environmentally friendly and
resource-saving recycling is ensured.
Depending on the implementation in national
law, you may have the following options:
• Return to a shop,
• Hand over to an official collection point,
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
Remedy
Check the socket, mains connection
cable, plug and fuse and have them
repaired by a qualified electrician if
necessary.
Contact the service centre.
Contact the service centre.
Contact the service centre.
Contact the service centre.
Reduce the pressure
Workpiece unsuitable
Tighten the grinding disc nut
(Replacing the grinding disc,
p. 26)
Replacing the grinding disc, p. 26
Attaching and adjusting the spark
guard, p. 25
Attaching and adjusting the
workpiece support, p. 25
Tighten the grinding disc nut
(Replacing the grinding disc,
p. 26)
Remove blockages