VEVOR 9926 Bedienungsanleitung Seite 16

• any other condition that may affect its safe operation.
2. After use, wipe external surfaces of the tool with clean cloth.
3. Regularly check to see if any dust or foreign matter has entered the
tool's air vents near the motor and around the trigger. Keep the vents
unclogged and clean at all times.
4. When a sanding belt tears or becomes worn, it must be replaced:
a. Always turn the tool off and unplug it before changing the belt.
b. Pull out the Belt Tension Release Lever and push it forward until it
locks into place.
c. Remove the old belt and replace with a new 3" x 21" belt. Make sure
the arrows on the inside of the new sanding belt are pointing in the
direction of rotation as indicated on the housing of the tool.
d. Push the Belt Tension Release Lever back in to secure the belt in
place.
e. Make sure the new belt is on-center before use.
5. To replace a worn or broken Drive Belt:
a. Make sure the tool is turned off and unplugged before changing the
belt.
b. Remove the two cover mounting screws holding the Drive Belt Cover
in place.
c. Remove the Drive Belt Cover.
d. Take out the worn or broken belt and install a new belt by sliding it
around the Large and Small Belt Pulleys.
e. Replace the Drive Belt Cover and secure it in place with the cover
mounting screws.
6. CARBON BRUSH MAINTENANCE.
The Carbon Brushes may require maintenance when the motor
performance of the tool decreases or stops working completely. Carbon
- 15 -