Maintenance And Servicing Instructions - Vevor 9926 Bedienungsanleitung

6. When sanding, use both hands to hold the tool and sand along the grain
for best results.
7. Hold the tool lightly on the workpiece and allow the tool to do the work.
Do not push down on the Belt Sander or move it along the surface too
fast.
8. To prevent accidents, turn off the tool and unplug it after use. Clean,
then store the tool indoors out of children's reach.
note: Using the correct speed for the job increases the life of the tool.

MAINTENANCE AND SERVICING INSTRUCTIONS

procedures not specifically explained in this manual must be
performed only by a qualified technician.
To Prevent Serious Injury From Accidental Operation:
Make sure that the trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
To Prevent Serious Injury From Tool Failure:
Do not use damaged equipment. if abnormal noise or vibration occurs,
have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. Before each use, inspect the general condition of the tool. Check for:
• loose hardware
• misalignment or binding of moving parts
• damaged cord/electrical wiring
• worn or torn sanding belt
• cracked or broken parts
- 14 -