VEVOR 9926 Bedienungsanleitung Seite 14

Workpiece and Work Area Set Up
1. Workpiece selection:
a. Workpiece must be free of foreign objects.
b. Wear a NIOSH-approved respirator and have appropriate ventilation
whenever sanding pressure-treated lumber.
2. Designate a work area that is clean and well lit. The work area must not
allow access by children or pets to prevent distraction and injury.
3. Route the power cord along a safe route to reach the work area without
creating a tripping hazard or exposing the power cord to possible
damage. The power cord must reach the work area with enough extra
length to allow free movement while working.
4. Secure loose workpieces using a vise or clamps (not ncluded) to prevent
movement while working.
5. There must not be objects, such as utility lines, nearby hat will present a
hazard while working.
General Instructions for Use
1. Hold Sander using Front Handle and Rear Handle only.
2. Make sure that the Trigger is in the off-position, then plug in the tool.
3. To start the tool, squeeze the Trigger; release the Trigger to stop.
4. For continuous operation squeeze the Trigger and push the Trigger
Lock to lock the tool on. To disengage the Trigger Lock and allow the
tool to turn off, squeeze the Trigger once and then release.
5. Adjust the Sander speed to suit different working material. Turn the
Speed Control Knob to a higher number for a faster speed or to a lower
number for a slower speed. Determine the optimum speed by testing on
a scrap piece of material.
- 13 -