Setting The Frequency; Duration Of Treatment - schwa-medico SchweißKiller Gebrauchsanweisung

2. Automatic control until hand or foot is removed from the water bath:
The intensity is automatically set to the pre-selected setting on the intensity
controller 1 once the patient comes into contact with the water bath with
electrodes (power display 4 lights up). The intensity is automatically, gradually
increased. Once the desired intensity is reached, the user removes a hand or
a foot immediately from the water bath and the device saves the last setting
before the interruption. The Sweat Killer marks the setting at this point and
is signalled by the Sweat Killer via the flashing current display (4). Now put
the hand/foot back into the water bath. The device sets the intensity level to
the previously saved value and carries out the treatment. The saved value is
deleted when the device is switched off or when the operations mode button
is twice depressed.
B Manual: intensity adjustment using the intensity controller
As soon as you are connected to the electrodes – either in the water bath
or via the electrodes in the sponge pouch on the armpits – you can increase
in this operations mode the intensity by continually turning the intensity
controller (1) clockwise until you feel a tingling sensation. The manual mode
is especially appropriate for feet treatment in as much as the hands are then
free to operate the device.

Setting the frequency

Set the frequency to between 5 kHz and 10 kHz using the frequency controller.

Duration of treatment

The duration of the treatment is restricted to a maximum of 15 minutes. The
stimulation ends automatically on completion of this time. The stimulation can be
ended at any time, even before completion of the 15 minutes, by switching off the
device using the intensity controller 1.
English
35