Ruris RX Explorer 1500M Handbuch Seite 30

EN
1. Position the bumper at the front of the tractor.
2. Fix the bumper in the four screws provided (two on each side). (Fig.
6)
5.6 Assemble the grass catcher.
WARNING: Never operate the tractor without the grass catcher.
Step 1: Installing the back panel
1. Align the holes on the top of the back panel (a) with the holes (b)
and secure them with screws. (Fig. 7A/Fig. 7B)
2. Align the two holes on the bottom of the rear panel with the holes in
the two support levers (c) and secure with screws and nuts. (Fig. 7A)
3. Fix the clamping clip (d) in the slot (e). (Fig.7C)
5. Mount the left/right brackets (f and g) and secure with the screws provided.
Step 2: To assemble the grass catcher
1. Assemble the rotating frame (a), lower fixing frame (b) and diagonal support (c) using screws and nuts as
shown in (Fig.7D)
2. Place the support assembly in the collection bin. (Fig.7E)
3. Place the top cover over the bracket assembly and secure using the self-tapping screws. (Fig. 7F)
4. Install the handle cover plate (d) into the top cover assembly from bottom to top and secure with self-
tapping screws (Fig.7G).
5. Insert the handle(s), then lock it with screw and nut(Fig.7H).
8