F) Effect Operation With Several Effect Lights - Renkforce EL603 Bedienungsanleitung

DMX channel Value
6 000
001-063
064-127
128-191
192-255
7 000
001-063
064
065-127
128
129-191
192
193-255
8 000
001-255
The strobe effect (DMX channel 1 = 128-249) does not influence the DMX channels 6, 7 and 8.
When channel 1 = 000, the effect light is switched off entirely.
Channel 2 takes precedence over the other channels. If the DMX value at channel 2 is changed, the func-
tions of the other channels are switched off until a value is changed on the other channels.

f) Effect Operation with Several Effect Lights

This operating mode is used to operate several equal LED spots in different compositions.
• Connect the DMX connections of the LED spots as described in "Setup of a Master-Slave Chain".
• Push the button MODE (6), until "E x" is displayed (7) ("x" shows the ID of the LED spot).
• Set the corresponding ID ("E 1" to "E 9") for each LED spot. Up to 9 LED spots can be connected this way.
The first LED spot is assigned ID "E 1", the second one ID "E 2", etc.
The LED spot with the index "E 1" is the master device, the following effect lights are the slave devices.
Observe the position of the individual LED spots and their IDs in the following examples.
• Keep the button MODE (6) at the master device pushed and use the buttons UP (5) and DOWN (4) to set the effect
speed SP 1 to SP 9:
SP 1 = slow speed
SP 9 = high speed
30
Function
No effect
Fade effect red/green/blue slow >> fast
Fade effect red/green slow >> fast
Fade effect red/blue slow >> fast
Fade effect green/blue slow >> fast
Lights off
Permanent light red dark >> bright
Lights off
Permanent light green dark >> bright
Lights off
Permanent light blue dark >> bright
Lights off
Permanent light white dark >> bright
Sound-to-light mode off
Sound-to-light mode on