Use With An External Dmx Controller - Renkforce 1435563 Bedienungsanleitung

For a more detailed explanation of the individual menu items from the table, see the following items of these
instructions.
b) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the control-
ler. This DMX starting address specifies the first DMX channel to which the effect light responds. The remaining
control channels come after this first DMX channel (DMX starting address).
The effect light requires 9 or 15 free DMX channels depending on the operating mode.
Setting the DMX starting address
• In the menu, select DMX Addr and push the ENTER button.
• Select the desired starting address 001-512 with the arrows.
• Press the ENTER button to confirm your selection.
Setting the DMX channel number
• In the menu, select CH Mode and push the ENTER button.
• Select the desired number of DMX channels (9 or 15) with the arrows.
• Press the ENTER button to confirm your selection.
Setting the operating mode DMX
• In the menu, select Work Mod and push the ENTER button.
• Select the option DMX with the arrows.
• Press the ENTER button to confirm your selection.
In DMX mode, the LED DMX next to the display will flash.
Setting master-slave mode
• In the menu, select Master and push the ENTER button.
• Select the option No = Slave mode or Yes = Master mode with the arrows.
• Press the ENTER button to confirm your selection.
If the device is to be operated as a single device (standalone), it must be defined as a master device.
Only one device in a master-slave-chain must be defined as master device. All other devices must be
defined as slave devices.
Depending on whether the device is defined as master or slave, the corresponding LED next to the display
will flash.
29