Maintenance And Cleaning; Handling - Renkforce EL603 Bedienungsanleitung

12. Maintenance and Cleaning

Always observe the following safety instructions before cleaning or servicing the effect light:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work is carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected from all
power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations must perform repairs.
Never use any aggressive cleaning agents, cleaning alcohol or other chemical solutions, since these may
damage the casing or even impair function.
• Always disconnect the product from the power supply before cleaning it.
• Use a dry, lint-free cloth for cleaning the product.

13. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold to a warm
environment. The resulting condensation may destroy the device. Allow the device to reach room temperature
before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the intended
grip areas.
• Unplug the mains plug from the mains socket if you are not using the device for an extended period of time.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never put any filter foils, masks or other materials over the light exit. This may cause heat damage and danger of
fire.
• The device may heat up during operation. Never touch the casing during operation. Let the effect light cool off after
operation before touching or cleaning the casing.
• Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any objects
like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0.5 m around the device.
• The device is not suitable for continuous operation. Consistent compliance with operating breaks increases the
operational life span of the device. Let the device cool off for an extended period before taking it into operation
again.
33