Configuring The Multifunction Flange; Saving Settings - Abicor Binzel Rtm Abix Easyteach Originalbetriebsanleitung

RTM ABIx EasyTeach

5.3 Configuring the multifunction flange

The inputs for the multifunction flange must be configured in order to be able to use the multifunction flange.
Fig. 5
Select menu <Installation> → <General> → <Tool I/O>.
1
Set <Tool Output Voltage> to 24 V.
2
The <Freedrive> function must be assigned to the tool input <0>.
Fig. 6
Select menu <Installation> → <I/O Setup>.
3
In the left-hand column select the <tool in [0]> input and select <Freedrive> under <Action>.
4

5.4 Saving settings

The settings are saved only when the software is shut down.
Press the power button on the operating panel to shut down the software.
1
Confirm the prompt to save.
2
Configuring the output voltage
Setting Freedrive
5 Configuring the software
DE - 7