Initial Operation; Setting Up - Parkside PHD 100 E2 Originalbetriebsanleitung

GB
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not pull the plug from the
socket by the cable. Protect the
cable from heat, oil and sharp
edges.
• Do not carry or fix the equip-
ment by the cable.
• Use only extension cables that
are protected from spray water
and designed for outdoor use.
Always fully unroll a cable
drum before use. Check the ca-
ble for damage.
• Before any work on the equip-
ment, during work breaks and
in the case of non-use, remove
the plug from the socket.
• The cross-section of the power
supply cable must not be less
than 2 x 2,5 mm².
• Wear sturdy footwear to protect
against electric shock.

Initial Operation

In keeping with current regulations
a pressure washer must never be
operated off the drinking water
mains supply without a controlla-
ble backflow preventer. A suitable
backflow preventer in conformity
with EN 12729 type BA must be
used.
Water that has passed through a backflow
preventer is classified as undrinkable.
A backflow preventer is available
from specialist retailers.
2 2
• Employ an ordinary garden hose for
the water intake and ensure sufficient
length.

Setting up

• Insert the accessory holder
B
(6) into the attachment on the
reverse-side of the device (see
small image).
• Screw the equipment side of the
high-pressure hose connection
(2) to the high-pressure hose con-
nection (3) on the equipment.
• Insert the high-pressure connec-
tion on the gun side (1) into the
spray gun (10).
• Establish the water supply by
connecting the rapid-action wa-
ter supply connector to the water
connection with sieve insert
A
( 9).
• Connect to the spray gun (10)
C
by inserting and screwing in the
jet tube (11).
• If the jet pipe (11) is fitted, screw
in with the jet pipe (11) to con-
nect either the adjustable fan
nozzle (12) or the high pressure
nozzle (13).
• Screw in to connect the deter-
gent container with nozzle (
14) directly to the spray gun
(10). With using the cleaning
agent container with the noz-
A
zle ( 14), pour only cleaning
agent into the container. It is
sucked in automatically.
The width of the jet can be increased by
turning the end of the nozzle to the left. To
reduce the width of the jet, turn the end of
the nozzle to the right.
A