Working With The Equipment - Parkside PHD 100 E2 Originalbetriebsanleitung

GB
and understand the associated
dangers. Children must not play
with the device.
• Use the equipment only on a
flat, stable surface.
• The transport handle is exclu-
sively for transporting the equip-
ment. The equipment is portable
but not to be carried during
operation.
• For your safety, it is recom-
mended that you wear safety
glasses, safety boots and gloves
and, if necessary, ear protec-
tion.
• In the event of a fault or defect
during operation, immediately
switch off and unplug the equip-
ment. Then read
operating instructions
sible fault causes or contact our
service centre.

Working with the equipment

Caution: to avoid accidents
and injuries:
CAUTION. pressure
washers can be dan-
gerous if they are not
operated correctly!
The jet must never
be directed at peo-
ple, animals, electric
equipment connected
to the power supply
or against the actual
pressure washer.
• Do not direct the jet at your-
self or others in order to clean
clothes and shoes.
2 0
page 28 of the
for pos-
• Do not operate the pressure
washer when other people are
in the immediate vicinity, other
than they are also wearing pro-
tective clothes.
• Always use the spray gun with
both hands. This will enable
you to safely counter the recoil
force from the emerging water
jet.
• Take appropriate measures to
keep children away from the
equipment whilst it is running.
• Dispose of the packaging mate-
rial correctly.
• Do not use the equipment in the
vicinity of flammable liquids or
gases. Non-observance will re-
sult in a risk of fire or explosion.
• Do not spray combustible liq-
uids. Risk of explosion.
• Store the equipment in a dry
place and out of reach of chil-
dren.
• Children must be supervised in
order to ensure that they do not
play with the equipment.
• Ensure that no exhaust emis-
sions occur within the vicinity of
air inlets.
Caution! To avoid damage
to the equipment and any
possible person injury
resulting from this:
• Do not work with damaged or
incomplete equipment, or with
equipment that has been con-
verted without the approval of
the manufacturer. Before initial
operation, have a specialist
check that the required