Checking The Battery Charge Level On The Product; Operation; Switching The Product On/Off; Adjusting The Nozzle - Parkside Pdsa 20-Li C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

1 . Remove the battery pack
the product .
2 . Insert the battery pack
battery charger
3 . Connect the mains plug
socket‑outlet .
4 . When the battery pack
charged: Remove the battery
pack from the battery charger
Disconnect the mains plug
the socket‑outlet .
˜ Checking the battery charge
level on the product
NOTE
The battery pack
u
inserted in the product to check
the charge level .
The charge level of the battery
u
pack is indicated by the battery
[ 34 ]
status display
Switch the product on .
o
The charge level of the battery
o
pack is indicated by illumination
[ 34 ]
of the corresponding LED lights:
LED
red – yellow –
green
red – yellow
red
˜ Operation
WARNING!
m
Wear eye protection!
Wear a dust mask!
22 GB
from
[ 34 ]
into the
[ 34 ]
.
36 ] [
to a
[ 39 ]
is fully
[ 34 ]
.
[ 36 ]
from
39 ] [
must be
[ 34 ]
on the product .
18 ] [
Status
Battery pack fully
charged
Battery pack half
charged
Battery pack needs
to be charged
WARNING!
m
Check the product for obvious
u
defects (e .g . cracks) before each
use . Check the proper functioning
of the spray nozzle
WARNING!
m
Switch off the product and
remove the battery pack
before replacing attachments,
cleaning and when not in use .
˜ Switching the product on/off
Switching on: Move the on/off
o
switch to position I .
17 ] [
Switching off: Move the on/off
o
switch to position O .
[ 17 ]
˜ Adjusting the nozzle
NOTICE!
m
If you turn the spray nozzle
u
far to the right, the spray nozzle
can be unscrewed .
NOTE
The spray nozzle
u
infinitely adjusted from spray mist
to jet .
Spray mist: Turn the spray nozzle
o
to the left from the user's viewpoint .
Jet stream: Turn the spray nozzle
o
to the right from the user's viewpoint .
Turning the spray nozzle
o
right makes the beam selectively
more intense .
.
8 ] [
21 ] [ [ 34 ]
too
[ 8 ]
can be
8 ] [
8 ] [
8 ] [
to the
[ 8 ]