Cleaning And Maintenance; Cleaning - Parkside Pdsa 20-Li C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Problem
The tank is full but
the product does not
spray or sprays at a
low rate .
The motor stops
suddenly .
˜ Cleaning and maintenance
WARNING!
m
Switch off the product and
remove the battery pack
before replacing attachments,
cleaning and when not in use .
˜ Cleaning
WARNING! Risk of electric
m
shock!
The product must not be sprayed
u
with water or cleaned under
running water .
NOTICE!
m
Do not use chemical, alkaline,
u
abrasive or other aggressive
detergents or disinfectants to
clean this product as they might be
harmful to its surfaces .
Wear protective equipment (e .g .
u
gloves, safety googles) during

cleaning .

Never blow the spray nozzle
u
with your mouth .
24 GB
Possible cause
The spray nozzle
8 ] [
completely or partially
blocked .
The liquid is too thick and
therefore unsuitable .
The battery pack
21 ] [
discharged .
21 ] [ 34 ] [
Cleaning the container
1 . Clean the container
2 . Release the water via the filler
3 . Allow the container
Cleaning the housing
o
Cleaning when the spray nozzle
is clogged
1 . Clean the hole in the spray nozzle
out
[ 8 ]
2 . Rinse the spray nozzle
3 . Allow the spray nozzle
Solution
is Clean the spray nozzle
Remove the liquid from
the container
the spray lance
container .
Charge the battery
is
34 ] [
pack
[ 21 ]
NOTE
Clean the product immediately
u
after each use .
Regular proper cleaning helps to
u
ensure safe use and prolongs the
life of the product .
Foreign bodies can accumulate in
u
the spray nozzle
spray nozzle .
clean water .
opening .
out completely .
Clean the housing with a damp cloth .
of residue with a needle or thin
wire (not included in the scope of
delivery) .
clear water .
dry completely .
.
[ 8 ]
. Clean
10 ] [
and the
[ 7 ]
.
[ 34 ]
and block the
8 ] [
with
10 ] [
to dry
[ 10 ]
8 ] [
with
[ 8 ]
to
[ 8 ]