Inserting/Removing The Battery Pack; Charging The Battery Pack - Parkside Pdsa 20-Li C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

˜ Inserting/removing the
battery pack
(Fig . F, G)
WARNING!
m
Switch off the product and
remove the battery pack
before replacing attachments,
cleaning and when not in use .
NOTE
The product can be operated either
u
with X 20 V TEAM or X 12 V TEAM
battery packs .
1 . Fold up the battery cover
2 . There are 2 different battery
compartments:
The upper battery compartment
–
is intended to be used with the
12 V battery pack .
The lower battery compartment
–
is intended to be used with the
20 V battery pack .
3 . Inserting the battery pack:
12 V: Insert the battery pack
–
fully into the upper battery
compartment
into place .
20 V: Insert the battery pack
–
fully into the lower battery
compartment
into place .
4 . Removing the battery pack: Press
the release button
battery pack
21 ] [
battery pack .
20 GB
[ 21 ] [ 34 ]
.
15 ] [
[ 26 ]
34 ] [
until it clicks
25 ] [
21 ] [
until it clicks
[ 26 ]
on the
[ 20 ] [ 35 ]
. Pull out the
[ 34 ]
˜ 20 V battery pack – charging
information
˜ Checking the battery pack
charging level
(Fig . H)
Check battery pack charge level:
o
Press the
charging level LEDs
LED
Red/yellow/green
Red/yellow
Red
˜ Charging the battery pack
(Fig . I)
NOTE
[ 25 ]
If the battery pack
u
Allow the battery to cool down
completely before charging .
The battery pack
u
charged at any time without
reducing the life .
Interrupting the charging process
u
does not damage the battery
pack .
21 ] [
Charge the battery pack
u
operation when it is at medium or
low charging level .
1 . The charging control LEDs (green
and red
[ 32 ]
charger
[ 31 ]
LED
Red LED lights up
Green LED lights
up
Green and red LED
flashing
button . The
[ 29 ]
light up:
[ 28 ]
Charging level
Maximum
Medium
Low
is warm:
21 ] [
may be
21 ] [
before
[ 21 ]
) indicate the status of the
and the battery pack
Status
Battery pack
charges
Battery pack fully
charged
Battery pack
defective
33 ] [
:
21 ] [