Preparing The Spray Surface; Before Use; Charge Battery Pack (See Fig. B); Attaching/Disconnecting The Battery Pack To/From The Appliance - Parkside PFSA 20-Li A1 Originalbetriebsanleitung

Preparing the spray surface

♦ Cover the area around the spray area thoroughly
and over a wide area. Any surface that is not
masked could become contaminated.
♦ Make sure that the spray surface is clean, dry
and free of grease.
♦ Polished surfaces should be lightly sanded and
the sanding dust removed.

Before use

Charge battery pack (see fig. B)
CAUTION!
► Always unplug the appliance before you
remove the battery pack
to the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level must be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦ Insert the battery pack
charger .
♦ Insert the power plug into the socket. The red
control LED lights up to indicate that the
appliance is charging.
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready.
♦ Push the battery pack
│ GB │ CY
■ 8
from or connect it
into the high-speed
into the appliance.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the battery pack
it clicks into place.
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the charge level of the battery. The status
is indicated in the adjacent battery display LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Setting up

Assembly/disassembly

♦ Move the ▸ mark on the spray unit
mark on the motor unit . Now, turn the spray
unit until the ▸ mark on the spray unit
locks into the mark on the motor unit
♦ Release the catch
5a
the spray unit to the
unit to separate the two units.

Selecting/changing the nozzle

Nozzle Use
all types of paints and
1.8 mm nozzle
lacquers
viscous spray material
2.6 mm nozzle
♦ Undo the union nut
it from the spray unit
♦ Fit the desired nozzle
head .
♦ Screw the union nut
unit .
into the handle until
and remove the
to
to the
.
. Turn the ▸ mark on
mark on the motor
completely and remove
.
onto the nozzle
back onto the spray
PFSA 20-Li A1