Parkside PFSA 20-Li C3 Originalbetriebsanleitung Seite 12

NOTE
► Ensure that the spray material and thinning
agent are compatible. Using an unsuitable
thinning agent may cause clots that clog the
appliance. Never mix synthetic resin var-
nishes with cellulose thinners.
► To find out which thinning agent is suitable
for your spray material (water, paint thinner),
refer to the manufacturer's notes provided
with the spray material.
► Granular products and products containing
solids must not be sprayed. Their abrasive
effect shortens the service life of the appliance.
Preparing the spray surface
♦ Cover the area around the spray area thoroughly
and over a wide area. Any surface that is not
masked could become contaminated.
♦ Make sure that the spray surface is clean, dry
and free of grease.
♦ Polished surfaces should be lightly sanded and
the sanding dust removed.
Before use
Charge battery pack (see fig. B)
CAUTION!
► Always unplug the appliance before you
remove the battery pack
to the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level must be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
♦ Insert the battery pack
charger .
♦ Insert the power plug into the socket. The red
control LED lights up to indicate that the
appliance is charging.
PFSA 20-Li C3
from or connect it
into the high-speed
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready.
♦ Push the battery pack
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the battery pack
it clicks into place.
Removing the battery pack
♦ Press the release button
battery pack .
Checking the battery charge level
♦ Press the battery charge level button
check the charge level of the battery. The status
is indicated in the adjacent battery display LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Setting up
Assembly/disassembly
♦ Move the ▸ mark on the spray unit
mark on the motor unit . Now, turn the spray
unit until the ▸ mark on the spray unit
locks into the mark on the motor unit
♦ Release the catch
5a
the spray unit to the
unit to separate the two units.
Selecting/changing the nozzle
Nozzle
1.5 mm nozzle
1.8 mm nozzle
2.2 mm nozzle
2.6 mm nozzle
into the appliance.
into the handle until
and remove the
to
to the
. Turn the ▸ mark on
mark on the motor
Use
Low viscosity
Water-based paints
High viscosity
Oil-based paints
GB │ IE │
.
7 ■