Canyon GRIZL R126 Schnellstartanleitung Seite 46

POWER SUPPLY
8.2 FCC Compliance Statement (USA)/
Industry Canada (IC)
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
This device complies with part 15 of the FCC
Rules for Intentional Radiators and with ISED
license-exempt RSS(s).
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any
interference received, including
interference that may cause undesired
operation.
Cet appareil est conforme aux normes RSS
exemptes de licence d'Industrie Canada.
Son fonctionnement est soumis aux deux
conditions suivantes :
1. Cet appareil ne doit pas causer
d'interférences
2. Cet appareil doit accepter toute
interférence, y compris les interférences
pouvant provoquer un fonctionnement
indésirable.
46
8.3 RF exposure safety
This device complies with the FCC and ISED
RF exposure limits and has been evaluated
in compliance with mobile exposure
condition.
The equipment must be installed and
operated with a minimum distance of 1 cm
of the human body.
To achieve this distance, the use of the
device inside the bike frame is mandatory.
8.4 Class B device notice
Note: This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
USA/CAN
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
This Class B digital apparatus complies with
Canadian ICES-003.