Inhaltsverzeichnis
Werbung
1a
1a
1b
1b
5
5
8
8
12
14
8228395-04.indd 14
2
3
2
3
6b
6b
6a
6
a
9
9
English
English
RE PLAC ING THE DU ST BAG, S-BAG™
1
Replace the s-bag™ as soon as the indicator window
becomes fully red – raise the nozzle from the base to see this
(1a); or when the window lights up (1b).
2
Remove the hose and open the lid.
3
Pull the cardboard holder to remove the s-bag™. This auto-
matically closes the dust bag and stops dust from leaking
out.
4
Insert a new s-bag™ by pushing the cardboard holder
straight down in its tracks. Close the lid.
Note: Replace the s-bag™ even if it is not full (it may be blocked).
Also replace after using carpet-cleaning powder. Use only Electrolux
original dust bags – s-bag™ Classic, s-bag™ Clinic or s-bag™
4
4
Anti-odour.
Replacing the motor filter (Ref. No. EF54)
(Replace the filter for every 5th replacement of the s-bag™)
5
Remove the old filter
6
Insert a new filter in the groove (6a).
To make replacement easier, open the container by pressing
on it as shown in (6b).
7
Replace the filter and close the lid.
Cleaning the washable HEPA filter (Ref. No. EFH13W)
(When the indicator lamp comes on or for every 5th
replacement of the dust bag)
8
Open and remove the lid, then remove the filter.
9
Rinse the inside (dirty side) of the filter in warm tap water.
Tap the filter frame to remove excess water. Repeat four
times and allow the filter to dry.
Note: Do not use cleaning agents and avoid touching the delicate filter
surface.
10
Replace the filter and lid as shown.
7
7
10
1
0
11/15/06 2:43:52 PM
Werbung
Inhaltsverzeichnis
