Switching Off The Device; Cleaning; Cleaning The Device - Steinbach Poolrunner Smart Rxb 450 Originalbetriebsanleitung

6. Follow the instructions of the app and select the desired parameters.
7. Check and confirm the set values.
The cleaning program has been configured and saved.

Switching off the device

Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
Stopping cleaning
The device stops cleaning automatically as soon as the rechargeable battery is almost discharged. The
status indicator flashes yellow while the appliance is moving towards the pool wall and has assumed
6
the park position.
Lifting the device out of the pool
1. Attach the hook
threat it into the handle of the device.
Never attempt to lift the device by the charging
cap strap !
5
2. Slowly pull the device towards the water
surface until you can reach the handle.
3. Slowly lift the device out of the water and hold
it above the water surface.
After 10 to 15 seconds, most of the water that
has collected in the housing has drained back
into the pool.
4. Switch off the ON/OFF switch
The status indicator
soon as the device has switched itself off.
5. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued trouble-free operation.

Cleaning

Only clean the device with a standard bathroom cleaner, clear tap water and a lint-free cloth. Aggressive
cleaning agents can damage the device. Dry the device with a lint-free cloth.

Cleaning the device

1. Remove and clean the filter.
2. Rinse the device after each use with plain tap water inside and out.
The device is clean.
to a telescopic rod and
2
.
10
is lit red and goes off as
6
8
29