Switching Off The Device - Steinbach Poolrunner Battery Basic Originalbetriebsanleitung

1. Hold the device by the handle and
lower it slowly into the water until all
the air has escaped. The device should
run at a right angle to the pool wall.
2. Press the ON/OFF switch
bottom until it snaps into place.
The device beeps if it is switched on outside of the water.
The device starts approximately 15 seconds after the switch has been
pressed.
3. Afterwards, carefully lower the device on the nylon cord of the floating handle
the bottom.
The device is in the pool and starts cleaning with a time delay.
Cleaning stops automatically when the rechargeable battery is drained.
Press the ON/OFF switch
the cleaning time is up.

Switching off the device

Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
on the
13
to stop cleaning and switch the device off before
13
11
12
13
to
5
39