Herunterladen Inhalt Inhalt Diese Seite drucken

Switching Off The Device; Cleaning; Cleaning The Device - Steinbach Poolrunner Battery Basic Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für Poolrunner Battery Basic:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
2. Press the ON/OFF switch
If the ON/OFF switch is pressed when the device is not in the water, it beeps and does not turn on.
The device switches on 15 seconds after it is lowered into the water.
3. Let the device sink to the bottom while you slowly feed the nylon cord of the floating handle
lower the device in a controlled manner.
Make sure that the device lands on the bottom of the pool on its underside and that cleaning can
start without obstruction towards the center of the pool.
The device is in the pool and starts cleaning with a time delay.
Cleaning stops automatically if the rechargeable battery dies. Press the ON/OFF switch
to stop cleaning early and to switch the device off.
13

Switching off the device

Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
Lifting the device out of the pool
1. Slowly pull the device to the surface by the floating handle
reach the handle
.
8
If the floating handle is out of reach, attach the supplied hook
the package contents) to reach the floating handle.
2. Slowly lift the device out of the water by the handle
After 10 to 15 seconds, most of the water that has collected in the housing has drained back into
the pool.
3. Press the ON/OFF switch
The device is switched off.
4. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued trouble-free operation.

Cleaning

Only clean the device with a standard bathroom cleaner, clear tap water and a lint-free cloth. Aggressive
cleaning agents can damage the device. Dry the product with a lint-free cloth.

Cleaning the device

1. Remove and clean the filter.
2. Rinse the device after each use with plain tap water inside and out.
The device is clean.
26
on the bottom until it snaps into place.
13
on the bottom until it snaps into place.
13
and the nylon cord until you can
5
to a telescopic rod (not included in
6
and hold it above the water surface.
8
to
5

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis