Set The Cleaning Programme Manually Via The Device; Configuring The Cleaning Program Via The App - Steinbach Poolrunner Smart Rxb 450 Originalbetriebsanleitung

6
10
1. Check that the cap
2. Press the ON/OFF switch
The status indicator
The device is switched on and ready for operation. The device must be placed in the water within 3
minutes, otherwise it will switch off automatically.
3. Hold the device by the handle and lower it slowly into the water until all the air has escaped.
4. Then let the device sink to the bottom of the pool.
Make sure that the device lands on the bottom of the pool on its underside and that cleaning can
start without obstruction towards the center of the pool.
The status indicator
The device is placed in the pool and starts cleaning with a time delay of around 20 seconds after
automatic calibration.

Set the cleaning programme manually via the device

The device can be used in the factory settings without using the app. The standard mode is the
complete cleaning of the pool ''Standard full pool''.
There are 3 cleaning modes that you can set manually directly on the device: Standard full pool, floor,
wall. (see chapter ''Description'').
1. Briefly press the ON/OFF switch
modes.
The display of the selected cleaning mode
The manually set cleaning programme is configured and saved.

Configuring the cleaning program via the app

When using the app, both WLAN and Bluetooth must be activated on your mobile phone. You must pair
the device with the app and configure the cleaning program while the device is out of the water before
placing the device in the pool and starting cleaning. Any settings you made are saved and applied in
future operation.
1. Activate Bluetooth and WLAN.
If you use an android device, you might have to activate GPS as well.
2. Press the ON/OFF switch
The status indicator
via Bluetooth.
3. Start the "Robo Control" app.
4. Search for available devices.
5. Select your device to connect it with the app.
The app signals the successfully established connection.
The status indicator
28
6 5
is firmly screwed onto the charging socket.
5
for approx. 2 seconds.
10
lights up green briefly, then the status indicator lights up blue continuously.
6
blinks blue.
6
on the appliance to switch manually between the cleaning
10
for approx. 2 seconds.
10
is lit blue. The device is ready for operation and ready to connect to the app
6
is lit purple. The device is connected to the app.
6
7
lights up blue.
11