Switching Off The Device - Steinbach Poolrunner S63 Originalbetriebsanleitung

Starting cleaning
1. Press the ON/OFF button
The device starts moving. The indicator
of the last selected cleaning cycle starts to
blink.
To change the cleaning cycle, press the CYCLE button
It is normal that the device knocks against the pool wall. You can adjust the
speed of the device with the two nozzles, see section "Basic settings".
Cleaning stops automatically at the end of the set cleaning cycle. All indicators

Switching off the device

Proceed as follows to switch off the device:
1. Switch off the device after the end of the cleaning program.
2. Disconnect the control unit from the power supply and the device.
3. Lift the device out of the pool.
4. Clean the filter unit and the device.
Switching off the device
1. Press the ON/OFF button
The device is switched off and all indicators
Press the ON/OFF button
up.
40
11
.
12
10
10
.
12
are off.
10
to stop cleaning the device before the time is
12
11 12
.
11
blink.
10