Configuring The Cleaning Program Via The App; Switching Off The Device - Steinbach Poolrunner Battery Pro Originalbetriebsanleitung

The device is in the pool and starts cleaning with a time delay.

Configuring the cleaning program via the app

You must pair the device with the app and configure the cleaning program while the device is out of the
water before placing the device in the pool and starting cleaning. Any settings you made are saved and
applied in future operation.
1. Activate Bluetooth.
If you use an android device, you might have to activate GPS as well.
2. Switch the ON/OFF switch
The status indicator
3. Slide the ON/OFF switch forward and back again (within at most 2 seconds).
The status indicator
4. Start the "Battery Pro Line" app.
5. Search for available devices.
6. Select your device to connect it with the app.
The app signals the successfully established connection.
The status indicator
7. Follow the instructions of the app and select the desired parameters.
8. Check and confirm the set values.
9. Switch off the ON/OFF switch
The status indicator
The cleaning program has been configured and saved.

Switching off the device

Proceed as follows to switch off the device:
1. Lift the device out of the pool and switch it off.
2. Clean the filter unit and the device.
Stopping cleaning
The device stops cleaning automatically as soon as the rechargeable battery is almost discharged. The
status indicator blinks yellow while the device moves to the pool wall and stays yellow as soon as it
4
has reached its end position.
Lifting the device out of the pool
1. Attach the hook to a telescopic rod and
2
threat it into the handle of the device.
Never attempt to lift the device by the charging
cap strap !
5
2. Slowly pull the device towards the water
surface until you can reach the handle.
3. Slowly lift the device out of the water and hold it
above the water surface.
After 10 to 15 seconds, most of the water that
has collected in the housing has drained back
into the pool.
4. Switch off the ON/OFF switch
The status indicator
soon as the device has switched itself off.
28
to ON.
6
is lit blue. The device is ready for operation.
4
blinks pink. The device is ready to connect to the app via Bluetooth.
4
is lit pink. The device is connected to the app.
4
.
6
is lit red and goes off as soon as the device has switched itself off.
4
.
6
is lit red and goes off as
4
8