Switching Off The Device - Steinbach Poolrunner S63 Originalbetriebsanleitung

2. Connect the plug of the floating cable
the right position to the control unit
screw the connection together.
3. Attach the control unit
least A=3.5 m to the pool with the safety rope
so that it cannot be pulled into the water.
7
4. Connect the power plug to a grounded socket.
The control unit is connected.
Starting cleaning
1. Press the ON/OFF button
The device starts moving.
2. Press the CYCLE button
different cleaning cycle.
The indicator of the last selected cleaning
10
cycle starts to blink.
The device starts cleaning
It is normal that the device knocks against the pool wall. You can adjust the speed of the
device with the two nozzles; see section "Basic settings". Cleaning stops automatically at
the end of the set cleaning cycle. All indicators

Switching off the device

Proceed as follows to switch off the device:
1. Switch off the device after the end of the cleaning program.
2. Disconnect the control unit from the power supply and the device.
3. Lift the device out of the pool.
4. Clean the filter unit and the device.
Switching off the device
1. Press the ON/OFF button
The device is switched off and all indicators
28
in
1
and
5
at a distance of at
5
.
12
to switch to a
11
.
12
are off.
10
6
1
7
A
7 5
8
10
11
blink.
10
5
5
12