Leuze RSL210 Originalbetriebsanleitung Seite 53

Elektrischer Anschluss
HINWEIS
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules (Contains FCC ID: A8TBM78ABCDEFGH). These limits
are designed to provide reasonable protection against harmful interference in a residential ins-
tallation. This equipment generates, uses and can radiate radio frequency energy, and if not in-
stalled and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the Leuze Service Hotline or an experienced radio technician for help.
This device complies with Industry Canada's license- exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'lndustrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage;
(2) I'utilisateur de I'appareil doit accepter tout brouillage radioélectrique subi, méme si le brouil-
lage est susceptible d'en compromettre le fonctionnement.
Guidelines on Transmitter Antenna for License Exempt Radio Apparatus:
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To re-
duce potential radio interference to other users, the antenna type and its gain should be so cho-
sen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for
successful communication.
Conformément la réglementation d'lndustrie Canada, le présent émetteur radio peut fonctionner
avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par In-
dustrie Canada. Dans le but de réduire les risques de brouillage radioélectrique I'intention des
autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope
rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire I'établissement d'une com-
munication satisfaisante.
Leuze electronic GmbH + Co. KG RSL210 53