3. TECHNICAL CHARACTERISTICS
3.1. Electric impulses of the device (Fig.1) have output pa-
rameters as follows:
3.1.1. the impulse minimal parameters:
– duration of the impulse positive part,
us, not exceeding...........................................................5
– amplitude of the impulse positive part,
V, not exceeding............................................................10
– amplitude of the impulse negative part,
V, not exceeding............................................................10
3.1.2. maximal parameters of the impulse:
– duration of the impulse positive part, us................500±70
– amplitude of the impulse positive part, V.................30±10
– amplitude of the impulse negative part, V,
without load .........................................................350±70
with load (20 ± 5%) kOhm......................................300±70
3.1.3. Minimum load resistance under which the parameters
of the impulse keep, Rmin.......................................500 Ohm
Vpp*
Duration of the impulse
* Vpp — voltage peak to peak
Figure 1. Impulse form
EN
79