RC ART DiaDENS-PC Betriebsanleitung Seite 117

GOOD
HEALTH
Operating VOLL mode with connecting to personal com-
puter
Install software from the СD on personal computer (this has
to be done just once) according to the User Manual for the
DiaDENS-PC software.
Connect the device with the computer by cable from the
complete assembly, as shown in the Figure.
DENAS MS
code +7 (343)
STAND-BY
P00 F77
Attention! The patient will hold passive electrode in his/her
hand opposite to the side under testing (e.g. when testing the
To exit from "VOLL", press the "V" key.
To switch the device off, press the "Off"
key. The device will display the messages
"GOOD HEALTH" and "GOOD BYE" and, af-
GOOD
BYE
Switch the device on.
To do this, press "On" key. A sound track
will be played and manufacturer information
will appear on the screen (20 sec).
Following that, the device will go into
STAND-BY mode.
For skipping manufacturer information,
press and hold any key (except the "Off")
until "STAND-BY" appears on the screen.
Connect the diagnostic electrodes to the
slot.
To set the VOLL mode press "V" key. Start
the VOLL programme on the computer. For
further studies see the software reference
information.
ter a musical fragment,
the device will switch off.
EN
117