RC ART DiaDENS-PC Betriebsanleitung Seite 104

EN
SCR
STAND-BY
Attention! The power control will depend on patient's feel-
ings, at the moment of the electrode contact with skin surface.
The pain sensitivity threshold should not be exceeded.
At the moment of switching the device on, the power value
will be zero.
SCR
P42 F10
SCR
P00 F10
Attention! During operation of the device in the SCRЕENING
mode, the electrodes on the patient's skin should be estab-
lished in the "stable" way, i.e. one must not shift the device
electrodes directly during its operation in the SCRЕENING
mode.
104
For skipping manufacturer's message,
press and hold any key (except the "Off")
until STAND-BY appears on the screen.
Switch on the SCREENING mode.
To do this, press the "FREQUENCY
–" key until the first line of SCR appears.
Establish the device electrodes on the se-
lected skin area (Section 6).
Set the action power.
For increasing the power press and hold
"POWER +" key. The power will start in-
creasing evenly from 0 to 99 conventional
units. On the screen, the change of power
from P00 to P99 will be shown, for instance
P42.
For decreasing of the action power press
and hold "POWER –" key. The power will
start decreasing evenly from 99 to 00. On
the screen, the change of power from P99
to P00 will be shown.