RC ART DiaDENS-PC Betriebsanleitung Seite 122

EN
Operating BIOVOLL mode with connecting to personal
computer
Install the software from the СD to personal computer (this
will have to be done only once) according to the User Manual
for the DiaDENS-PC software. Connect the device to the com-
puter by cable from the complete assembly. Connect diagnos-
tic electrodes to the cable slot.
BIOVOLL
Ut = ?
5.7. The BIOREPER mode
Bioreper is a method of functional electropuncture auricular
diagnosis (on external ear). The study will be performed at test-
ing voltage individual for each patient, i.e. with due considera-
tion of individual electric conductivity.
Attention! The mode is intended for evaluation of functional
condition of internal organs and systems rather than diagnosis.
We can discuss conditions when the function is reduced, nor-
mal or activated.
Highly significant will be findings for specific organs (exis-
tence of points representing concrete organs).
The technique allows us to reveal pathological conditions at
"pre-disease" stage, select the optimal treatment procedure
and examination, to evaluate functional condition of diseased
organs and systems in dynamics, when performing another
testing. Due to low current (lower than 15 uA) in measurement
points, no morphological changes occur.
Preparing for diagnosis
Two days prior to the diagnosis procedure, it is recommend-
ed that patient avoids tonics. On the day of the diagnosis, two
hours before the procedure, the patient should avoid taking
coffee, or tea, or food. Immediately before the procedure, it is
122
Switch the BIOVOLL mode by simultane-
ous pressing the "On" and "V" keys. Start
the programme. For further studies see the
software reference.
The technique and rules of testing are
presented in the Section Operating BIOVOLL
mode autonomosuly.