RC ART DiaDENS-PC Betriebsanleitung Seite 105

When the device finds contact of the electrodes with skin sur-
face, the message STAND-BY will be replaced with indication
of the stable time interval: 5 seconds, during which changing
of the trigger zone condition will be determined in response to
SCR
T = 5 s
SCR
ΔLT = 8
STAND-BY
P35 F77
5.1.3. The THERAPY mode
The THERAPY mode operates:
– at frequencies of 1.0 to 9.9 Hz (with the minimal step 0.1
Hz);
– at frequencies of 10, 20, 60, 77, 140 and 200 Hz;
– in therapeutic modes 77.10 and 77AM.
At operation in THERAPY mode, both the zonal (with the aid
of inbuilt electrodes) and pointed (with the aid of remote elec-
trode) action.
Recommendations for choosing therapeutic frequencies:
– 1.0-9.9 Hz – "infraslow". These will be used for action upon
biologically active points and zones with altered parameters
revealed after electropuncture diagnosis performed by the
method of VOLL or BIOVOLL. Treatment formula and choice of
impulse sent by the device. On termination
of the 5-second period, the device emits a
brief sound signal and displays measure-
ment result in the form of index ΔLT (with-
in the range from 0 to 100 units), e.g. = 8.
Make notice of the value obtained.
Move to diagnosing the next zone.
Those zones whose ΔLT values differ
considerably from the majority of num-
bers either towards increase or decrease
will be the latent trigger zones. These
zones must be treated in THERAPY mode
during 1-5 minutes at the frequency of
60 or 77 Hz. To do this, press the "FRE-
QUENCY +" key until appearance on the
screen of F60 or F77 and treat the zones
at the second (comfortable) energy level.
EN
105