RC ART DiaDENS-PC Betriebsanleitung Seite 113

STAND-BY
P00 MED
patient's skin should be established in the "stable" way, i.e. one
must not shift the device electrodes during the procedure.
After setting the action power, the message "STAND-BY" will
TEST
T=00:03
T=15
T=00:03
will begin: continuous stimulation for 5 minutes; a message
THERAPY
T=05:00
THERAPY
T=01:07
key. The device will display the messages "GOOD HEALTH" and
GOOD
HEALTH
and hold "POWER –" key. The power will
start decreasing evenly from 99 to 00. On
the screen, the change of power from P99
to P00 will be shown.
Attention! During operation of the de-
vice in the MED mode, the electrodes on the
be replaced with a message of beginning of
the MED mode I phase: the TEST regime.
On stabilising of the skin resistance be-
neath the electrode, the device will emit
sound signal and in the upper line of the
screen for a few seconds the time of testing
action will be displayed.
Then the second phase of the MED
"THERAPY" will appear and time counting
will begin in respect to minimally effective
dose of the device action. On termination of
the 5 minute period, a sound signal will be
emitted indicating completion of the MED
mode.
To switch the device off, press the "Off"
"GOOD BYE" and, after a musical fragment,
the device will switch off.
GOOD
BYE
EN
113