RC ART DiaDENS-PC Betriebsanleitung Seite 101

5.1.1 ТЕSТ mode
ТЕSТ mode is intended for evaluation of functional condi-
tion of the body organs and systems by means of searching
for zones where the skin electrical resistance will sharply differ
from adjacent areas (the latent trigger zones (it is also intended
for treatment of the skin areas symmetrical to the complaint
projection (the symmetry principle).
Attention! In the ТЕSТ mode, search for latent trigger zones
will be performed rather than diagnosis.
The energy range: minimal or comfortable. The operating
method: stable (the electrodes will be shifted after receiving a
sound signal).
The ТЕSТ mode only works at the frequency of 10 Hz. In
treatment, the built-in electrodes only will be used.
DENAS MS
code +7 (343)
STAND-BY
P00 F77
STAND-BY
P00 MED
Switch on the device.
To switch the device on press the "On" key. A
sound track will be played and manufacturer
information will be displayed on the screen
(20 sec).
Following that, the device will switch to the
STAND-BY state.
For emergency termination manufacturer
information, press and hold any key (except
the "Off") until appearance on the screen of
the STAND-BY state.
Choose the MED mode.
Keep pressing "FREQUENCY –" key until
"MED" appears on the screen.
Establish the device electrodes on the se-
lected skin area (Section 6).
Set the action power.
EN
101